FlashPro-ARM and GangPro-ARM Device List Overview

These devices can be programmed by all adapters:

Texas Instruments - MSP (ARM), TIVA, Stellaris, SimpleLink(ARM)
ST Microelectronics - STM32 Fx, Lx, Gx, Hx, WB, WL, Ux, BlueNRG
Silicon Labs - EFM32, EFR32, EM, SiM3
Silergy - MAX7xxxx
Renesas - Synergy, RA
NXP / Freescale - i.MX RT, Kinetis, LPC, S32, K32
Nordic Semiconductors - nRF
Microchip/Atmel - SMART SAMx
Maxim - MAX32xxx
Marvell - 88M
GigaDevice - GD32-E23x
Infineon / Cypress - FM0+, FM3, FM4, PSoC 4, PSoC 5LP, PSoC 6, PSoCAn, IMC
Analog Devices - Precision
Active Semi - PAC5x

Serial Flash Support Overview
Using FlashPro-ARM and GangPro-ARM software the XStreamPro-Iso adapter can use the target MCU (i.e. STM32H7) as a proxy to program these serial external flash devices over JTAG/SWD, as long as the external flash device is properly configured using the MCU’s SPI peripheral interface, such as OCTOSPI, Dual-QSPI, QSPI, SPI, etc.

NOR memory:
Adesto
Cypress
GigaDevice
ISSI
Macronix
Microchip
Micron
Winbond 

Serial Flash memory can be programmed directly via SPI using FlashPro-M or GangPro-M software.

4-June-2024
==================================================================
version 2.87
  Added current measurement DLL functions that access samples history buffer (duplicating GUI Energy and Power Monitor graph), rather than just instantaneous Vcc/Icc that is received from F_Get_Power_Results
    DLL functions added: F_Get_Power_Results_Start, F_Get_Power_Results_Stop, F_Get_Power_Results_History
  Added custom register initialization options in Setup->Device Reset->Customize Register Initialization dialog.  The listed addresses will be written to with specified values right after comm (JTAG/SWD/etc.) initialization.
  Patch to Maxim shutdown procedure
  Patch for loading Image file
  Patch for Gang protection programming when some targets fail
  Update for U5 firmware, and added new U5 part numbers
  Update for MSPM0 init procedure